Skip to content
DOCS

Your first plugin in Studio

Install Freqlab Studio, make a plugin, hear it, and open it in your DAW.

About 20 minutes, most of it the first-time install of the build tools.

1. Install and set upLink to this section

Download Freqlab Studio from the Downloads page and open it. Setup walks you through:

  • Build tools: click Install on each missing one. This is the slow part.
  • Agent (optional): Skip for now if you'd rather write the code yourself. See Build a plugin with an AI agent.
  • DAWs: pick the DAWs you use, so Studio knows where to put your plugins.

Details: Install and set up. Want a walkthrough instead? Take the tour.

2. Make a pluginLink to this section

Click New Plugin (+), choose Quick Setup, and answer three short steps: a name and whether it's an effect or an instrument, the framework, and the interface. Not sure? Keep Effect and WebView UI, and pick any framework. Click Create.

You get a small working plugin: a gain control for an effect, or a simple synth. See Create a plugin.

3. Build itLink to this section

Press ⌘B (Ctrl+B on Windows). The first build takes a few minutes; later ones are much faster. If it fails, the Output panel says why. See Build.

4. Hear itLink to this section

Click Start Preview. Your plugin's window opens. Click Controls, then pick something to play through it: a sample or test signal for an effect (then press Play), or the piano for an instrument. See Preview your plugin.

Change the code and build again: the preview reloads with the new build.

5. Open it in your DAWLink to this section

Click Publish to DAW, check the formats and DAWs, and click Publish. Rescan plugins in your DAW, and it's there. See Publish to your DAW.

NextLink to this section