Preview your plugin
Load your plugin into Studio to hear it, reload it on every build, and compare, reset and bypass it.
Studio can run your built plugin itself, so you hear every change without opening a DAW.
Start the previewLink to this section
- Build the project.
- Click Start Preview at the top of the window. Your plugin loads and its window opens.
- Click Controls to open the Plugin Controls panel, then pick something to play through it (see Audio and MIDI sources).
The preview plays the CLAP build. Studio always builds VST3 and CLAP; an imported project's own files must build a CLAP too (Import tells you if they don't). Plugins with No Custom UI have no window, so they can't be previewed: test them in a DAW.
If you close the plugin's window, Reopen brings it back.
Each build reloadsLink to this section
While the preview runs, every successful build reloads into it automatically, and its window reopens where it was. The new build starts at its default settings, and Compare's A and B are cleared. Restoring a version loads that version's build; if it has no build, the preview stops until you build it.
Plugin ControlsLink to this section
You set your plugin's parameters in its own window. Plugin Controls is for everything around it:
| Section | What's in it |
|---|---|
| Input Source | What plays into the plugin. See Audio and MIDI sources |
| Actions | Screenshot, Reset to Defaults, A/B compare, Bypass |
| Monitoring | Meters and analyzers, channel layouts and Listen on (Surround and headphones) |
| Performance | Plugin CPU and build timing |
| Validation | The Freqlab Standard checks |
| Debugging | Real-time Check, Probes, Tracy and Capture |
Output Volume at the top sets how loud the preview plays through your speakers. Output is clipped at 0 dBFS, so it never goes past your interface's maximum.
ActionsLink to this section
- Compare switches between two sets of settings, A and B. B starts as a copy of A. Your changes go to whichever one is selected.
- Bypass (effects) lets you hear the input without the plugin, delayed to match its latency.
- Attach for Agent (with an agent set up) attaches a picture of the plugin's window to your next chat message.
Reset to Defaults and Compare need a plugin that can save its settings (CLAP's state extension).
Audio settingsLink to this section
Set the output device, sample rate (48 kHz by default) and buffer size (512 by default) in Settings, Audio. Use the same sample rate as your DAW. Click Apply: the preview goes quiet for a moment while it changes.