Meters and analyzers
Watch your plugin's levels, spectrum, waveform and stereo field while it plays.
Open Controls, then Monitoring. Each display has its own On/Off switch. Output meters and Plugin Channels start on; input meters, spectrum, waveform and stereo field start off.
Level metersLink to this section
Input (Pre-FX) shows what goes into an effect; Output (Post-FX) shows what comes out.
- The bar is the peak level. The tick and number are the highest recent peak.
- A red dot means the level went past 0 dB. Click it to clear it.
- RMS adds a thin bar for the average level.
Plugins with more than two output channels also get Plugin Channels: one meter per channel, before they're mixed down for listening.
SpectrumLink to this section
The frequency spectrum, in dBFS. Hover it to read the frequency, note and level at that point.
- Peaks holds the highest levels.
- Pre/Post (effects) overlays the input, so you see what your plugin changed.
- The settings button (it shows the range, like "90 dB") sets the Range, Resolution, Speed and Tilt dB/oct (4.5 by default, so a mix looks roughly flat).
- DC shows any DC offset; it turns amber when it's high enough to matter.
WaveformLink to this section
The audio over time, from 1 to 85 ms across. Wave draws it; X/Y plots left against right to show phase.
- Trig keeps a repeating wave still.
- Channel picks L/R, L, R or Mono.
- Pre/Post (effects) stacks the input above the output.
Stereo FieldLink to this section
How wide the sound is, with a correlation meter from +1 (mono) to −1 (out of phase). Pre/Post overlays the input; Compare shows them side by side.